Troy-bilt PONY TB465SS Manuel d'utilisateur télécharger pdf (Page 5)

ASSEMBLY INSTRUCTIONS

ADJUSTING THE D-HANDLE

1. Locate the wing nut on the D-Handle. Loosen the wing nut

enough to loosen the D-Handle (Fig. 6).

NOTE: Do not remove wing nut, washer, or bolt.

2. Rotate the D-Handle to the upright position on the front

side of the shaft housing (Fig. 6).

NOTE: The D-handle

should slant

towards the

powerhead of the

unit.

3. Hold the unit in the

operating position (Fig.

16). If necessary,

reposition the D-

handle to the location

that provides the best

grip.

4. Tighten the wing nut

until the D-Handle is

secure.

TB465SS

1. Slide the cutting attachment shield into the shield mount on

the cutting attachment. Align the screw holes in the shield

with the holes in the cutting attachment (Fig. 4).

Fig. 4

INSTALL CUTTING ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield

on your unit is not installed. Use only the instructions that apply

to the type of shaft and shield that your unit is equipped with.

TB415CS

1. Place the cutting attachment shield onto the shaft housing.

Be sure the guard mounting bracket slides into the slot on the

edge of the cutting shield. Rotate the shield into place,

counterclockwise. The holes in the guard mounting bracket

and cutting attachment shield will line up (Fig. 1).

2. From inside the cutting attachment shield, push the square bolt

through the hole until the threaded end protrudes through the

guard mounting bracket (Fig. 2).

3. Put the washer on the bolt, then screw the wing nut onto

the bolt and tighten. Figure 3 shows the installation

process from underneath the unit.

Fig. 1

Fig. 2

Shaft Housing

Fig. 3

(4) Screws

Guard

Mounting

Bracket

Cutting

Attachment

Shield

Cutting Attachment

Shield

Square

Blot

Fig. 5

2. Place a hex lock nut into one of the three recessed holes on

the top of the cutting attachment shield (Fig 5).

3. Install a screw into the hole from the bottom of the cutting

attachment shield and screw it into the nut installed in step

2 (Fig. 5). Do not tighten.

4. Repeat steps 2 and 3 until all three screws have been

started, then tighten securely.

WARNING: To prevent serious personal injury,

never operate the trimmer without the cutting

attachment shield in place.

Fig. 6

Wing Nut

Washer

Guard Mounting Bracket

1 2 3 4 5 6 7 8 9 10 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Troy-bilt PONY TB465SS Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Troy-bilt PONY TB465SS