Troy-Bilt TB22 EC Manuel d'utilisateur télécharger pdf

769-07307 P00 10/11

IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.

Removing Unit From Carton

Assemble The Unit

tarting The Unit

Slide shield’s slot onto

mounting bracket. Rotate

shield onto shaft. Push

square bolt through shield

nd bracket. Tighten

washer and wing nut

onto bolt.

Remove cap from lower

boom. Push cutting

ttachment into coupler.

Turn coupler knob clockwise

to tighten.

Assemble The Unit

ix thoroughly in separate

uel can:

– 3.2 fl. oz. of 2-cycle

engine oil

– 1 gallon of unleaded

gasoline

OTE: Do not mix directly in

uel tank.

Place unit on a level surface.

Fill fuel tank.

Press primer bulb 10 times,

or until fuel is visible

Crouch in starting position. SQUEEZE and HOLD

throttle for ALL further

steps.

Pull rope 5 times. Move choke lever to

Position 2 and squeeze

throttle.

Pull rope 3-5 times to start

engine. Run unit for 30-60

seconds to warm up.

Continue to squeeze

throttle. Move choke lever

to Position 3.

11 2

Remove all contents from

carton.

5 6 7

19 10

Put D-handle on shaft. Move

handle a minimum 6 inches

way from shaft grip. Insert

clamp bolt and tighten the

wing nut.

Move choke lever to

Position 1.

Continue to squeeze

throttle. Run unit for an

additional 60 seconds to

complete warm-up. Unit

may be used during this

time.

Starting The Unit

Primer

Bulb

10 X

5 X

3-5 X

Choke Lever

Starter Rope

Fuel Cap

Throttle Control

On/ Off Switch

D-Handle

Ez-Link™

Cutting Head Shield

Need Help?

Call 1-800-828-5500

Electric Starter or

Power Start Bit Optional!

THESE OPTIONAL ACCESSORIES

ARE SOLD SEPARATELY!

This unit has an alternate starting method

that many find easier to use than pulling a

rope. Please contact a local retailer or call

1-800-828-5500 for more information.

Information may also be found at

ww.troybilt.com

DIDN’T START?

Repeat these instructions.

IF engine fails to start after 2 attempts,

move choke lever to position 3 and pull

the starter rope until engine starts

IF unit still fails to start, refer to the

operator’s manual for additional starting

and troubleshooting information

1 Gallon 3.2 oz

40:1

Choke Lever

lot

Bracket

Min. 6"

o Assemnly

ools Required!

Bump

Knob

Inner

Reel

Outer

Spool

Spring

Top Hole

Bottom Hole

Split Wall

Unscrew the bump knob

counterclockwise.

Remove the inner reel and

spring.

Cut one 6-foot (1.8 m) length

of new 0.095” split line

trimming line. Split each end

about 6 inches (150 mm).

Insert the end of one line into

the top hole and the end of

the other line into the bottom

hole.

Wind the line tightly in the

direction shown on the inner

reel. The split wall will divide

the line. Wind the line until it

is completely divided and

about 6 inches (150 mm) of

line remains.

Insert the two 6-inch sections

into the two .095 holding

slots.

11 2

Pass the two line ends

through the eyelets. Place the

spring inside the inner reel.

Insert the inner reel into the

outer spool. Push the inner

reel and outer spool together.

Reloading the Line*

Hold the inner reel and outer

spool together. Firmly pull the

two line ends to release them

from the holding slots. Screw

the bump knob on clockwise.

Tighten the bump knob

securely.

For replacement line, call 1–800-800-7310 or go to

an authorized service dealer.

For single line installation or replacement spool

installation instructions, refer to the Replacing the

Trimming Line section of this manual.

*This is to assist in the reloading of Splitline® only. These instructions

are NOT part of the fast assembly instructions. Line does not need to

be installed on the initial assembly and start-up.

Reloading the Line

Holding Slots

Eyelets

NEED HELP? CALL 1-800-828-5500 IN U.S. OR 1–800–668–1238 IN CANADA

TB22 EC

2-Cycle Trimmer

Operator’s Manual

English — Page 1

Español — Page 6

1 2 3 4 5 6 ... 15 16

Résumé du contenu

Page 1 - Operator’s Manual

769-07307 P00 10/11IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.Removing Unit Fro

Page 2 - SAVE THESE INSTRUCTIONS

10LIMPIEZA Y ALMACENAMIENTOLIMPIEZAUse un cepillo pequeño para limpiar la parte exterior de la unidad. No use detergentes fuertes. Los limpiadoresdomé

Page 3 - NO ASSEMBLY TOOLS REQUIRED

11CAUSA ACCIÓNEl combustible está viejo (más de 30 días) y/o malmezcladoDrene el tanque de combustible y eche combustiblefresco mezclado adecuadamente

Page 4 - WARNING:

12NOTES

Page 5 - ROUBLESHOOTING

13NOTES

Page 6 - Manuel de l’utilisateur

14NOTES

Page 7 - CONSERVE ESTAS INSTRUCCIONES

15NOTES

Page 8 - AUCUN OUTIL NECESSAIRE

16The limited warranty set forth below is given by Troy-Bilt LLC (“Troy-Bilt”) with respect with new merchandise purchased and used in the United Stat

Page 9

2• SAFETY AND INTERNATIONAL SYMBOLS •This operator's manual describes safety and international symbols and pictographs that may appear on this

Page 10 - Función de Arranque Eléctrico

STARTING INSTRUCTIONS1. Mix fuel with oil. Fill fuel tank with fuel/oil mixture. See Oil and Fuel MixingInstructions.2. Fill the fuel tank with fresh,

Page 11 - ESPECIFICACIONES*

REPLACING THE TRIMMING LINEOnly use the trimming line described in the Specifications section. Other types oftrimming line may cause the engine to ove

Page 12

5SPECIFICATIONSCLEANING AND STORAGECLEANING Use a small brush to clean off the outside of the unit. Do not use strong detergents. Household cleaners t

Page 13

PerillapercusivaCarreteinteriorBobinaexteriorResorteAgujerosuperiorAgujeroinferiorRanuras de sujeciónIMPORTANTE: LEA BIEN EL MANUAL DEL OPERADOR Y, AL

Page 14

7• SIMBOLOS DE SEGURIDAD E INTERNACIONALES •Este manual del operador describe los símbolos y figuras de seguridad e internacionales que puedenaparec

Page 15

CONOZCA SU UNIDADAPLICACIONESComo recortadora; •Corte de césped y hierbas delgadas• Recorte de bordes• Recorte decorativo alrededor de árboles,cercos,

Page 16 - TROY-BILT LLC

9INSTRUCCIONES DE OPERACIÓNCOMO SOSTENER EL RECORTADORAntes de operar esta unidad, párese en posición de operación (Fig. 10). Verifique lo siguiente:•

Commentaires sur ces manuels

Pas de commentaire

Troy-Bilt TB22 EC Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Tondeuses à gazon Troy-Bilt TB22 EC. Troy-Bilt TB22 EC User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Troy-Bilt TB22 EC