Troy-Bilt TB3000 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Tondeuses à gazon Troy-Bilt TB3000. Troy-Bilt TB3000 User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 22
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
©2000 MTD SOUTHWEST INC
Models
TB3000 –
25cc Straight Shaft
FORM 182823 (12/00) (10209 rev. A)
Printed in U.S.A.
Owner/Operator
Manual
2-Cycle Trimmer
Safety
Assembly
Operation
Maintenance
Vue de la page 0
1 2 3 4 5 6 ... 21 22

Résumé du contenu

Page 1 - 2-Cycle Trimmer

©2000 MTD SOUTHWEST INCModelsTB3000 – 25cc Straight ShaftFORM 182823 (12/00) (10209 rev. A)Printed in U.S.A.Owner/OperatorManual2-Cycle Trimmer• Safet

Page 2 - Introduction

10Section 4Oil and FuelOil and Gas Mixing InstructionsOld and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure

Page 3 - Identification Numbers

11Section 5 OperationSTARTING INSTRUCTIONSOperate this unit only in a well ventilated areaoutdoors. Carbon monoxide exhaust fumes canbe lethal in a co

Page 4 - Section 1

12Operation (continued) HOLDING THE TRIMMERAlways wear eye, hearing, foot and body protec-tion to reduce the risk of injury when operatingthis unit.Be

Page 5 - Safety (continued)

13Operation (continued) Fig. 5-6DECORATIVE TRIMMINGDecorative trimming is accomplished by removing allvegetation around trees, posts, fences, etc.Rota

Page 6

14Maintenance (continued) SlottedHolesFor Use with MembraneLine or Single LineFor Use withSingle Line ONLYLoopFig. 6-3Fig. 6-4LINE INSTALLATIONThis se

Page 7

15Maintenance (continued) Membrane Line Installation8. Take approximately 20 feet (6.1 m) of new trimmingline. Insert one end of the line through one

Page 8 - Know Your Unit

16Fig. 6-9Fig. 6-11Fig. 6-12Fig. 6-10Maintenance (continued) AIR FILTER MAINTENANCECleaning the Air FilterTo avoid serious personal injury, always tur

Page 9 - Assembly

17Maintenance (continued) If after checking the fuel mixture and cleaning the air filter the engine still will not idle, adjust the idle speedscrew as

Page 10 - Oil and Fuel

18Maintenance (continued) ACCESSORIES/REPLACEMENT PARTSSpark Plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 181765Spark Arr

Page 11 - Operation

19Section 7 TroubleshootingCAUSE ACTIONCutting attachment bound with grass Stop the engine and clean cutting attachmentCutting attachment out of line

Page 12 - Operation (continued)

2IntroductionTHANK YOUThank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service.You will fin

Page 13 - MAINTENANCE

20Section 8SpecificationsEngine Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Page 15

MANUFACTURER’S LIMITED WARRANTY FOR:No implied warranty, including any implied warranty ofmerchantability or fitness for a particular purpose,applies

Page 16

3Service Information SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized anda

Page 17

The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols,and their explanations, deserve your careful attent

Page 18

5Safety (continued) • Always stop the engine and allow it to cool before filling the fuel tank. Never remove the cap of the fueltank, or add fuel, whe

Page 19 - Troubleshooting

6Safety (continued) SAFETY AND INTERNATIONAL SYMBOLSThis operator's manual describes safety and international symbols and pictographs that may ap

Page 20 - Specifications

SYMBOL MEANING• SHARP BLADEWARNING: Sharp blade on cutting attachment shield. To prevent serious injury, do not touch line cutting blade.• CHOKE CONTR

Page 21

8Section 2Know Your UnitAPPLICATIONSAs a trimmer; • Cutting grass and light weeds.• Edging• Decorative trimming around trees, fences, etc.With the opt

Page 22 - MTD Southwest Inc

9Section 3 AssemblyOn some units, the D-handle may be preinstalled andonly require loosening the screws and adjusting the D-handle to the operator. Go

Commentaires sur ces manuels

Pas de commentaire