Troy-Bilt LS 27 TB Manuel d'utilisateur télécharger pdf (Page 12)

Operation

Starting & Stopping the Engine

Refer to the Engine Operator’s manual packed with your log

splitter for instructions on starting and stopping the engine.

Using the Log Splitter

Operating Positions

1. Place the log splitter on flat, dry, solid ground.

2. Block the front and back of both wheels. See Figure 5-1.

Horizontal

Vertical

Figure 5-1

3. Place the beam in either the horizontal or vertical position

and lock into place.

WARNING! Take extra care when raising and

lowering the beam as it is fairly heavy. Having a

second person assist with raising or lowering the

beam is recommended. Be sure to keep hands away

from any possible pinch points.

4. To place the beam in the vertical position proceed as

follows:

WARNING! Always use the log splitter in the

vertical position when splitting heavy logs.

a. Pull the horizontal beam lock out to release the

beam and pivot the beam to the vertical position.

b. To lock the beam in the vertical position, pull out on the

vertical beam lock and rotate it to secure the beam. See

Figure 5-2.

Vertical Beam Lock

Figure 5-2

5. To place the beam in the horizontal position proceed as

follows:

a. Pull the vertical beam lock out and rotate it down.

Pivot the beam to the horizontal position.

b. The horizontal beam lock is self-locking. The spring

loaded lock will snap into place when the beam is

lowered into position. See Figure 5-3.

Horizontal Beam Lock

Figure 5-3

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Pas de commentaire

Troy-Bilt LS 27 TB Manuel d'utilisateur Page 12