Troy-bilt 030245 Manuel d'utilisateur télécharger pdf (Page 10)

Stopping the Engine

1. Turn OFF and unplug all electrical loads from generator

panel receptacles. NEVER start or stop engine with

electrical devices plugged in and turned ON.

2. Let engine run at no-load for several minutes to

stabilize internal temperatures of engine and generator.

3. Turn engine off according to instructions given in the

engine operator’s manual.

4. Move fuel valve to “Off” position.

RECEPTACLES

120/240 Volt AC, 30 Amp, Locking

Receptacle

Use a NEMA L14–30 plug with this receptacle. Connect a

4–wire cord set rated for 250 Volt AC loads at 30 Amps (or

greater) (Figure 5).You can use the same 4–wire cord if you

plan to run a 120 Volt load.

This receptacle powers 120/240 Volt AC, 60 Hz, single

phase loads requiring up to 5,550 watts of power

(5.55 kW) at 23.1 Amps for 240 Volts or two independent

120 Volt loads at 23.1 Amps each.The outlet is protected

by a double pole rocker switch circuit breaker.

120 Volt AC, 20 Amp, Duplex

Receptacles

Both duplex receptacles (Figure 6) are protected against

overload by a double pole rocker switch circuit breaker.

Use each receptacle to operate 120 Volt AC, single–phase,

60 Hz electrical loads requiring up to 2,400 watts (2.4 kW)

at 20 Amps of current. Use cord sets that are rated for

125 Volt AC loads at 20 Amps (or greater).

GENERATOR ADAPTER

CORD SET

The generator comes with a 25’ generator adapter cord set

designed to provide two sets of 120 Volt, 20 Amp outlets from

one 120 Volt, 20 Amp duplex receptacle (Figure 7).

The maximum load on each outlet is 20 Amps.The

maximum total load on both black wire outlets or white

stripe wire outlets is 20 Amps.

NOTE: Follow all safety precautions when connecting any

extension cord or device to the generator.

Figure 6 — 120 Volt, 20 Amp Duplex Receptacle

• NEVER attempt to power a device requiring more amperage

than generator or receptacle can supply.

• DO NOT overload the generator. See “Don’t Overload

Generator”.

Receptacles may be marked with rating value greater

than generator output capacity.

CAUTION

Figure 7 — Generator Adapter Cord Set

Figure 5 — 120/240 Volt AC, 30 Amp Receptacle

4-Wire Cord Set

240V

120V

W (Neutral)

X (Hot)

Y (Hot)

NEMA L14-30

Ground (Green)

Section 4: Operation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Troy-bilt 030245 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Troy-bilt 030245